Knowledge

PP melt-blown filter cartridges are typically designed for single use and are not recommended for cleaning and reuse. They should be replaced immediately if the water flow rate drops by ≥30%, the pres

The manufacturing process of PP meltblown filter cartridges is a process that uses food-grade polypropylene (PP) as raw material, and through steps such as high-temperature melting, high-speed spinnin

Choosing the right PP wound filter cartridge requires comprehensive consideration of its gradient filtration structure ("loose on the outside, dense on the inside"), the fluid characteristics of the t

The core function of PP wound filter cartridges is to efficiently remove suspended solids, particulate impurities, rust, and colloids from liquids through a deep filtration structure. They are charact

A chlorine taste in the water, a deterioration in taste, a decrease in flow rate, or the filter cartridge turning black or yellow are all clear signs that your CTO activated carbon block filter cartri

The core function of CTO activated carbon block filter cartridges is to efficiently adsorb residual chlorine, odors, organic matter, and some heavy metals in water, significantly improving the taste a

After replacing a CTO activated carbon block filter cartridge, it is recommended to rinse at a low flow rate for 10 to 15 minutes until the water is clear with no black water or foam. Your meticulousn

CTO activated carbon block filter cartridges should be installed after pre-filter cartridges such as PPF, with the water flow direction aligned with the arrow on the filter housing. Ensure a tight sea

When using a 5-micron PP cotton composite filter cartridge in areas with high water hardness, it should be installed after the main water meter and before other water-related appliances, ensuring the

Yellowing or blackening of the filter cartridge, slower water flow, and deteriorating water quality are all clear signs that a PP melt-blown filter cartridge needs replacement. You are not alone; many

PP meltblown filter cartridges are designed for single use only. Cleaning is not recommended by the manufacturer, and they cannot be reused. Cleaning not only fails to thoroughly remove internal dirt

Generally, PP melt-blown sediment water filter cartridges should be replaced every 3 to 6 months, depending on water quality and water usage.